Attention should be paid when using welding robots

Release time:

2024-10-05

　　So what are the points to pay attention to when using welding robots?

　　1. Before the robot performs automatic welding, the operator must teach the robot the trajectory of the welding gun and set welding conditions. Due to the necessity of teaching, robots are not designed for welding products with multiple varieties and small quantities of production.

　　2. It is necessary to ensure the accuracy of the workpiece. The robot has no eyes and can only repeat the same actions. The trajectory accuracy of the robot is ± 0.1mm, and the same actions are repeated with this accuracy. When the welding deviation is greater than the radius of the welding wire, it is possible that the welding is not good, so the accuracy of the workpiece should be kept within the radius of the welding wire.

　　3. The setting of welding conditions depends on the technical level of the teaching operator. When teaching, the operator must input the welding program, welding gun posture and angle, current, voltage, speed and other welding conditions. Teaching operators must fully master welding knowledge and techniques.

　　4. It must be fully noted that safety robots are high-speed moving equipment, and humans are absolutely not allowed to approach the robot during its automatic operation (safety barriers must be set up). Operators must receive specialized education on labor safety, otherwise they are not allowed to operate.

PRE

Industrial robots require essential knowledge in welding operations

The role of welding wire in welding robots

Application of 3D flexible wel

2024-11-19

The three-dimensional flexible welding platform achieves precise welding of comp

Learn More +

What kind of workpiece is suit

2024-10-05

Firstly, the workpiece standardization robot follows a fixed route, and if the workpiece is not standardized, the robot will weld off center.

Learn More +

What are the types of welding

2024-10-05

Pneumatic driven welding robot for switch control and secondary control. Due to the lower viscosity of compressed air, pneumatic transmission is easier to achie...

Learn More +

Promote welding and cutting automation related technologies.

✓ Reply Within 24 Hours

✓ Site Commissioning

✓ Customer Service Staff Provide Attentive Service

✓ OFFICIAL Website: www.xbznjx.com